Posts Tagged ‘Simplify3D Heated Build Platform

If you add a Heated Build Platform (HBP) to your MakerBot Replicator 2 3D printer you will need to do some modifications to your working process whenever you want to be able to print with a hot build plate. Using the MakerBot Desktop software with a Replicator 2 with HBP can be pretty easy just switching to the profile of a Replicator 2X, but there are some drawbacks. In order to be able to have more control on your prints with a Heated Build Platform on a Replicator 2 3D printer you probably would want to go for a different slicer such as the Simplify3D that we are already using. Since Simplify3D already has built-in support for Replicator 2 3D printers with installed HBP it is easier to take advantage of that along with the many other available options to control the printing process that the software offers. Enabling the HBP support and using it properly in Simplify3D however requires a bit more to make it work properly, so we are going to be looking at what steps you need to take.

hbp-firmware-configuration

First you need to enable the Replicator 2 with HBP profile in Simplify3D, to do that you need to do the following steps (we assume you have already selected a MakerBot Replicator 2 as the printer you are using in the slicer):

– Start the Simplify3D software
– Open the Tools menu and go into Firmware Configuration
– Go to the X3G tabl and under GPX Configuration select the Replicator 2 with HBP profile
– Click on Save and you are almost ready to go

hbp-code-1

Next you need to manually add some additional code to make sure your Replicator 2 3D printer will first heat the build plate before starting to print and that the temperature will be kept at the desired value until the print finishes. To do so follow the steps described below, the end result should look like on the screenshot above.

– Click on the Edit Process Settings Button
– Go to the Scripts tab and open up the Starting G-code
– Look for the following line of code: M126 S[fan_speed_pwm]
– After the above line of code you need to add the following two new lines:

M140 S[bed0_temperature] T0 ; heat build platform
M134 T0 ; stabilize build platform temperature

hbp-code-2

Then add some more extra code to make sure that the 3D printer will stop the heating of the build plate and cool it down after the printing finishes. To do so follow the steps described below, the end result should look like on the screenshot above.

– While still in the Scripts tab and open up the Ending G-code tab
– Look for the following line of code: M104 S0 T0 ; cool down extruder
– After the above line of code you need to add the following line:

M140 S0 T0 ; cool down heated build platform

hbp-temperature-set

After this you should be all ready to start 3D printing using the heated build platform on your MakerBot Replicator 2 3D printer, the only thing left too do is set the desired temperature of the Heated Build Platform that you want to use. You can do that with the following steps:

– Click the Edit Process Settings button of your current printing process
– Go to the Temperature Tab and click on the Add Temperature Controller
– Enter a name like HBP for example or Heated Build Platform
– Make sure that under Temperature Controller you select Heated Build Platform
– Set the desired temperature of the HBP by double clicking on the available Setpoint
– We are using 50-60 degrees Celsius for PLA (if needed) and 80-100 for ABS printing, use these as a reference


top